Products Info

Related Sites:

Easy Unique Web
Reverse Sensors
Auto Electronics Center
Security Camera E-Shop

Sound only, Backup Two Sensors System (BCE0030)

Item Price: $20.00
 Two ultrasonic sensors mount on your bumper with plugs to the control module which snaps in.
 The system alerts with a variable multitone audio pulse based on the distance changing.
 The system sensors transmit a modulated beam signal which is capable of seeing through fog, rain, smoke, and snow day or night.
 The device is only activated when the driver puts their vehicle into reverse.
 (Shipping & handling will be calculated based on the shipping zip code)
  
Step 1: Connect the Electric Power Step 2: Install the Backup Sensors for
           Insert-In Style Stick-on Style
  • Open the trunk, on the back of the blanket, find the wires to the back light housing.
  • Use of a 12 volt multi-meter, Probe the appropriate wiring harness which heads toward the reverse light connector of the vehicle, looking for the wire which carries 12 volts + when reverse gear is engaged, and no voltage when reverse gear is disengaged. Never use a test light to probe wires.

  • Once you have located the proper reverse light power wire, use a quick connector (included) to connect the RED wire from the control processer. You do not need to cut any wire.
  • Drill two holes through the license plate and the trunk.
  • Install two insert-style sensors with the special housings on the license plate as the picture shown.
  • Run the wires of sensors into the trunk, and plug in the control center.
  • Connect the power line of control center with the power line of backup light.
  • test the system.

  • (Note: The license plate holders are available for the two drill-in sensors version of the backup sensors system. Normally the sensors are in white since most of license plates are in white. They are free of charge. If you need them, please write a request on the comment field when place an order.)

    OR

  • Drill two or four holes in the bumper via provided drilling bit.
  • Install the insert-style sensors in the bumper.
  • Run the wires of sensors into the trunk, and plug in the control center.
  • Connect the power line of control center with the power line of backup light.